Earthfox
Gesperrter Benutzer
- Zuletzt hier
- 27.12.09
- Registriert
- 15.05.05
- Beiträge
- 248
- Kekse
- 34
Hab mir grad nen Single Rectifier gekaut, er hat 2 4Ohm Anschlüsse und einen 8 Ohm anschluss. Hab leider noch keine Box da und möchte testen ob er funktioniert. Ein Kumpel hat noch einen JCM 800 Combo mit einer 12er Box drin. Die Box hat allerdings 4 Ohm. Kann ich ihn an die Box des JCMs anschließen oder crash ich mein Top damit?
Sensitivity to speaker mismatching in regards to ohmage differences is low, hence no damage to the amplifier will occur. However,
very low ohmage loads will cause the power tubes to wear faster. The RECT-O 50 (combo only) is equipped with a Celestion
Custom 90 single 12 inch - 8 Ohm speaker, but as you can see, other speaker configurations may be
used. When using two 8 Ohm speakers, connect each of them to the 4 Ohm speaker jacks that are
provided, this will equal a 4 Ohm load which is the proper impedance required when using this particu-lar
speaker configuration.
4 OHM 4 OHM 8 OHM
SPEAKERS
Sensitivity to speaker mismatching in regards to ohmage differences is low, hence no damage to the amplifier will occur. However,
very low ohmage loads will cause the power tubes to wear faster. The RECT-O 50 (combo only) is equipped with a Celestion
Custom 90 single 12 inch - 8 Ohm speaker, but as you can see, other speaker configurations may be
used. When using two 8 Ohm speakers, connect each of them to the 4 Ohm speaker jacks that are
provided, this will equal a 4 Ohm load which is the proper impedance required when using this particu-lar
speaker configuration.
4 OHM 4 OHM 8 OHM
SPEAKERS
- Eigenschaft
